The MATEKSYS Hall Effect Current Sensor is a 150A sensor with factory calibrated Offset and Sensitivity.

Note: (Insert any product notes here in Red BOLD Italic. Example: "First Shipment expected January 2022" or "Electronics are Not Included".)

VIDEO: Diatone Mamba H743 MK4 FC & 128K ESC Unboxing

• No voltage drop and heat on current sensor components
• Offset and Sensitivity are calibrated in factory
• 0~150A DC Continuous current rating
• 17ma Power Consumption
• Hall effect current sensor

USE BULLETED FEATURE HERE IN BOLD CAPS.

Add additional feature descriptions here to describe the above.

USE BULLETED FEATURE HERE IN BOLD CAPS.

Add additional feature descriptions here to describe the above.

• VBAT voltage sense: 0~69V, INAV scale = 2100, BF scale = 210, ArduPilot BATT_VOLT_MULT = 21.0
• Sensitivity: 20mV/A, INAV/BF scale = 200, ArduPilot BATT_AMP_PERVLT = 50
• Voltage offset error at zero current: +-10mV
• Continuous current rating: 0~150A DC
• Operating Temperatures: -30~80 °C
• Current Output Voltage Error: 5%
• Power Consumption: 17mA
• Dimensions: 23x20x23mm
• Weight: 7g

SOLDERING PADS

• 5V: power supply for HCS-150A board, support 4~13V IN, 17mA
• TX/RX: for firmware update and configure (to be supported)
• Vbat: for voltage sense, support 0~69V IN
• Current: Current signal, 0~3.3V out
• Volt: = 1/21 Vbat, 0~3.3V out
• G: GND

IMPORTANT NOTES

• Mount Hall sensor far from iron and magnetic materials.

•  (Insert recommended products here. Example: "Battery: Lumenier 10000mAh 6s 25c Lipo Battery")

• Step File: HCS-150A_step.zip

• 1x MATEKSYS Hall Effect Current Sensor - 150A 

ADD VIDEO TITLE HERE IN BOLD CAPS

ADD VIDEO TITLE HERE IN BOLD CAPS