Hex Cube Purple (also known as Cube Mini) is an autopilot system designed specifically for land-based applications such as boats, cars, or rovers. This flight controller is based on the original Pixhawk 2.1 Cube Black main module, featuring an F4 chip, but offers a smaller platform suitable for situations where sensor redundancy isn't necessary. The Cube Purple Set, which includes a Mini Carrier board, serves as an optimal solution for compact drones. Moreover, it is compatible with both PX4 and APM firmware.

• 80-pin DF17 connector
• Built-in STM32F4 chip
• Single Baro Sensor
• Single IMU sensor
  
  

USE BULLETED FEATURE HERE IN BOLD CAPS.

Add additional feature descriptions here to describe the above.

USE BULLETED FEATURE HERE IN BOLD CAPS.

Add additional feature descriptions here to describe the above.

PROCESSOR

• 32-bit ARM Cortex M4 core with FPU
• 168 Mhz/256 KB RAM/2 MB Flash
• 32-bit failsafe co-processor

SENSORS

• InvenSense MPU9250 (accel and gyro) * 1
• IMU (accels, gyros, and compass) * 1
• MS5611 barometers * 1

INSIDE THE CUBE

• An STM32F100 I/O processor with pass-through capabilities for failsafe. (deals with the Receiver and outputs )
• An STM32F427 Rev 3 Flight management unit. (where the flight controller lives.)
  
  

IMPORTANT NOTES

• Please remember to install the firmware below!

•  (Insert recommended products here. Example: "Battery: Lumenier 10000mAh 6s 25c Lipo Battery")

• Firmware

• 1x Hex Cube Purple

ADD VIDEO TITLE HERE IN BOLD CAPS

ADD VIDEO TITLE HERE IN BOLD CAPS