Holybro Pixhawk PDB Board (for Pixhawk 6X & 6C)

This Holybro Pixhawk Power Distribution Board (PDB) is used for PM02, PM02D, or similar power modules. This PDB is perfect for the Pixhawk 6X & 6C products.

Power modules with build-in power distribution such as the PM03, PM06, and PM07 would not require this PDB.  

Note: Power modules with build-in power distribution such as the PM03, PM06, and PM07 would not require this PDB. This option does NOT include a XT30 pre-soldered cable. The option with XT30 pre-soldered goes perfectly with the ESC & Motor on the X500 V2.

VIDEO: (Insert Video Title here in Bold)

•  Used for PM02, PM02D or similar Power Modules

USE BULLETED FEATURE HERE IN BOLD CAPS.

Add additional feature descriptions here to describe the above.

USE BULLETED FEATURE HERE IN BOLD CAPS.

Add additional feature descriptions here to describe the above.

• Rated Current: 60A
• Max Current: 120A (<60 sec)
• 45x45mm Mounting Holes
• Dimensions: 50 x 50mm

IMPORTANT NOTES

• Insert important warnings or notes here. Example: "Do not overheat." or "Always use the included charger for best performance."

•  (Insert recommended products here. Example: "Battery: Lumenier 10000mAh 6s 25c Lipo Battery")

•   (Insert links such as manuals, firmware, etc)

• 1x Holybro Pixhawk PDB Board 

ADD VIDEO TITLE HERE IN BOLD CAPS

ADD VIDEO TITLE HERE IN BOLD CAPS