The ZEEZ F7 V2-Lite 2020 is an 8 Motor Output, DJI HD System Ready flight controller with an on-board 9V@3A regulator to power the DJI Air Unit and a 5V@3A regulator to power all the peripherals. It has almost the same specs and features as its big brother, the 3030 version, but without a barometer and in a more compact format.

It uses a powerful F7 processor along with top-of-the-line hardware with an MPU6000 Gyro. ZEEZ F7 V2-Lite 2020 comes in a standard 20×20 form factor. It comes with spaces and pads for TBS Crossfire and TBS Unify Nano32 for a very clean and low-profile assembly. It has 4 onboard RGB LEDs and easy-to-solder LED pads on each corner. There are 5 UARTS available as well as an I2C port, 16MB Flash memory for Blackbox data recording, an OSD chip for analog video, and LC Filter to power the Analog camera and VTX.

Zeez took all the feedback given to them from the previous version and has improved the overall stability and power supply cleaning. Zeez was able to reduce the size of the FC, thanks to its 6 layers design. Along with easier to solder pads and improved the strength of all the solder pads, adding additional copper around the pads.

Note: (Insert any product notes here in Red BOLD Italic. Example: "First Shipment expected January 2022" or "Electronics are Not Included".)

VIDEO: (Insert Video Title here in Bold)

• Onboard RGB LED distribution for clean wiring to the LED on the arm of the quad.
• Direct solder connection and board space for TBS Nano RX and TBS Unify Pro32 Nano providing the ultimate in clean stack installation.
• Logic Side and USB current protection
• Uses a powerful F7 processor
• DJI HD System Ready

USE BULLETED FEATURE HERE IN BOLD CAPS.

Add additional feature descriptions here to describe the above.

USE BULLETED FEATURE HERE IN BOLD CAPS.

Add additional feature descriptions here to describe the above.

• MCU: STM32F722 (216MHz max frequency)
• HD Plug for DJI AirUnit or CaddxVista: Yes
• Onboard 4 WS2812B RBG LED: Yes
• LC Filter for 5V VTX and CAM: Yes
• Memory: 16MB Onboard flash
• Mounting holes: 20x20mm
• LiPo Power input: 3S-6S
• USB: Type C connector
• Gyro/ACC: MPU6000
• BEC 5V-3A / 9V-3A
• OSD chip: Onboard
• Motor output: 8
• Barometer: NO
• I2C bus: 1
• UARTs: 5

IMPORTANT NOTES

• Insert important warnings or notes here. Example: "Do not overheat." or "Always use the included charger for best performance."

•  (Insert recommended products here. Example: "Battery: Lumenier 10000mAh 6s 25c Lipo Battery")

•  Download Wiring Diagram

• 1x Zeez RC F7 2020 Flight Controller V2 Lite
• 4x Aluminum Standoff
• 4x Aluminum Nut
• 1x ESC to Flight Controller 8pin to 8pin JST SH 1mm Connector
• 1x ESC to Flight Controller 8pin to Free Wires (with JST SH Crimp) JST SH 1mm Connector
• 1x JST SH 8 Pin Plastic Housing
• 1x JST SH 10 Pin Plastic Housing
• 2x 2.00mm Header Pin for VTX Connection
• 2x 2.54mm Header Pin for Receiver Connection
• 1x JST 5 Pin to Air Unit Connector

ADD VIDEO TITLE HERE IN BOLD CAPS

ADD VIDEO TITLE HERE IN BOLD CAPS