TATTU Plus2.0 18000mAh 6S1P 22.2V 15C Smart Lipo Battery
TATTU Plus2.0 18000mAh 6S1P 22.2V 15C Smart Lipo Battery
Out of Stock
About this product
Tattu Plus2.0 18000mAh 6S1P 22.2V 15C Intelligent Lipo Battery with AS150+XT150 plug will give your UAV the enough power for long time to fly. The Version 2.0 is the updated version of Tattu Plus series. 7 LED lights on the battery make it convenient for your use. It is easy to check the service life of the pack. Storage mode will be auto-activated.
Features
- Overheat protection
- Low temperature protection
- Over voltage protection
- Over current protection
- Intelligent Storage:
- Normal temperature range storage
- Above normal temperature storage 60-70℃ (158°F –176°F)
- Hot conditions storage 70-80℃ (158°F – 176°F)
- Local after-sales service(located in Dublin, CA)
Specifications
- Minimum Capacity: 18000mAh
- Configuration: 6S1P / 22.2V / 6Cell
- Discharge Rate: 15C
- Max Burst discharge Rate: 30C
- Net Weight(±20g): 2270g
- Dimensions: 205.5mm Length x 94.2mm Width x 79.5mm Height
- Discharge Plug: AS150+XT150 plug
- Charge Plug: XT90
|
Feature |
Tattu Plus |
Tattu Plus 2.0 |
|
Fuel Gauge |
YES |
Yes, the fuel gauge is run by a very accurate coulomb meter and impedance tracking circuit. This makes the fuel gauge display very precise. |
|
Self Balance in storage mode |
YES |
Yes, the pack will self balance the individual cells depending on the SOC(State of charge) difference during storage mode |
|
Discharge Low voltage warning |
LED Flash Warning |
Audible warning system |
|
Discharge over temperature warning |
LED Flash Warning |
Audible warning system |
|
Cycle life indicator |
NO | YES |
|
Defective Pack Warning |
NO | if you click the pack button and the fuel gauge shows red L.E.D.s, it is time to replace this pack. |
|
Battery low voltage warning |
NO |
Yes, if you click the button and the fuel gauge shows yellow L.E.D.s the pack voltage is low and you need to recharge. |
|
Battery storage indicator |
NO |
Yes, The storage is turned on if you click the button and the fuel gauge shows white L.E.D.s the pack is in storage mode. |
|
Advanced charging protection |
NO |
Yes, if the pack individual cell voltage is too low when charging is started,the BMS will limit the incoming charge current to battery until the voltage is correct, then accept full supplied charge current |
|
Voltage Overcharge Protection |
NO |
Yes, the overcharge protection circuit will activate when any cell voltage exceeds the factory set failsafe values. |
|
Charging over current protection |
NO |
Yes, charging over current protection circuit will be activated when charging current reaches factory set failsafe values. The protection circuit will remain active until charger is disconnected. |
|
Charging short circuit protection |
NO |
Yes, the protection circuit will cut off charging when it detects that the current reaches the factory set short-circuit protection limit. When protection is triggered all FETs will be turned off. |
|
High Temperature Charge Protection |
NO |
Yes, if the pack temperature exceeds factory set values It will not charge. When the pack is back in the correct temperature range it will charge normally |
|
Low Temperature Charge Protection |
NO |
Yes, if the pack temperature falls below factory set values the pack will not charge. When the correct temperature is back in range the pack will charge normally. |
|
Secondary Charge Protection |
NO |
Yes, Tattu Plus 2.0 has a secondary charging protection circuit. If the first level circuit has a failure, the second level of protection will cut the charging circuit off |
|
IIC communication port |
NO |
Yes, The IIC communication port is active. When you connect the batterypack to the computer software the IIC will allow you to read: pack voltage, individual cell voltage, rated capacity after full charge, remaining capacity, capacity percentage, cycle time, tem |
Includes
- 1x Tattu Plus2.0 18000mAh
No Air Shipping
Please note that shipping regulations have recently changed for batteries. We are no longer able to ship lithium polymer batteries via any Air shipping method. This includes all international destinations outside the USA. In the USA, you will only be presented with ground-based shipping options if your order contains a lipo battery. If you need to receive your order quickly and would like to ship with one-day or two-day shipping options, consider splitting your order into an order of only batteries (shipping ground) and everything else.
Due to IATA shipping regulations, batteries shipping AIR must have a charge of less than 30%. A lithium polymer battery that stays in this state for long periods of time will become damaged. For this reason, GetFPV does not ship batteries using Air shipping.
If you want to ship batteries via air shipping, you can set up an account through our freight forwarding partner MyUS.com. Follow the instructions on their website to learn more.
Warning
Only use a Lithium battery charger. Always monitor the battery while charging. Always store the battery in a safe, nonflammable container. Never overcharge or over-discharge the battery. Never damage, puncture, short circuit, or modify the battery. Never use a damaged Lithium battery.
More Information
| SKU | 7762 |
|---|---|
| Manufacturer | Tattu |
| NDAA Compliant | No |
| Voltage / Cell Count | 22.2 Volt (6 Cell) |
| Battery Capacity (mAh) | 18000 |
| C-Rating | 15 |
| Discharge Plug | AS150+XT150 |
| Item Returns | This item can be returned |