SpeedyBee Bee25 2.5" Cinewhoop - No FPV System

The SpeedyBee Bee25 2.5" Cinewhoop - No FPV System is a compact, high-performance drone built for custom FPV setups, offering stability and control in tight spaces. Powered by an STM32F405 flight controller, 35A ESC, and 1404-V2-4600KV motors, it handles demanding maneuvers with precision and supports up to a 4S LiPo battery. With compatibility for a 20mm camera lens and a molded VTX mount for the O3 Air Unit, the Bee25 is perfect for pilots aiming to capture cinematic shots with ease.

Choose your Receiver:

• TBS Crossfire
• ELRS 2.4GHz
• DJI PNP

Note: This cinewhoop is VTX Ready Only- the FPV system is not included, but it does support DJI O3 Air Unit & RunCam Link VTX.

• High-Performance Propellers
• Powerful Flight Performance
• Compact and Durable Frame
• Precise Control and Tuning
• Customizable FPV Setup
• Meteor LED System
• Battery Support

• VTX: None (Standard molded mount, compatible with O3 Air Unit)
• Voltage Input: 4S LiPo, 16.8V (Recommended: 650mAh–1100mAh)
• Bluetooth: Supported for FC tuning and Meteor LED
• Camera: None (compatible with 20mm width lens)
• Frame: SpeedyBee Bee25 Standard Version
• Receiver: PNP, TBS Crossfire, ELRS 2.4GHz
• ESC: 35A 8-bit ESC (with BlueJay firmware)
• Meteor LED: Standard with 88 LED beads
• Propeller: HQprop DT63mm, 3-blade
• Main Control: STM32F405
• Motor: 1404-V2-4600KV
• Gyroscope: ICM 42688-P
• Battery Connector: XT30
• OSD Chip: AT7456E
• Wheelbase: 120mm
• Black Box: 8MB
• Maximum Supported Battery Size:
  • Horizontal: 75(L) x 31(W) x 40(H) mm
  • Vertical: 64(L) x 31(W) x 40(H) mm
• Weight:
  • ELRS: 124g ± 2g
  • PNP: 122g ± 2g
  • TBS: 124g ± 2g

IMPORTANT NOTES

• Removal of the heat sink eliminates weight but may cause overheating of the unit. Please be cautious when flying and once your battery is connected, fly immediately. The airflow will keep the unit cool.)
• Naked vista has been activated and upgraded to the latest version, in order to avoid damage caused by upgrade failure, eliminating the need to upgrade again.
• Please make sure to install the propeller screws due to high-speed flights.
• When you install the propeller guard please use the proper screw size.

• iFlight Defender 25 Battery - 900mAh

•   (Insert links such as manuals, firmware, etc)

• 1x SpeedyBee Bee25 2.5" Cinewhoop - No FPV System (Choose Your Receiver)
• 1x 4pin Cable (PNP Version Only)
• 1x Antenna Mount (Left & Right)
• 1x Camera Dampening Silicone
• 1x Hardware Set
• 1x Battery Strap
• 1x Screwdriver
• 2x Antenna