RadioMaster RP2 ExpressLRS 2.4GHz Nano Receiver w/ Fixed SMT Antenna
RadioMaster RP2 ExpressLRS 2.4GHz Nano Receiver w/ Fixed SMT Antenna
In Stock
About this product
The RadioMaster RP2 ExpressLRS 2.4ghz Nano Receiver w/ Fixed SMT Antenna is an open-source receiver based on ExpressLRS. It features an ESP8285 MCU and an SX1280 RF chip. The RP2 has a built-in ceramic antenna which is super light and small in size and ideal for racing. The RP2 features WIFI built in so you can upgrade firmware by WIFI and configure the Receiver via the built-in WebUI with your PC or mobile phone. Due to the low-latency and high-refresh-rate RF module, the RP2 is ideal for FPV racing or Long Range flights. Suitable for Whoops, drones, and fixed-wing models due to the ultra-light and Nano size, these receivers can fit just about anywhere!
Note: (Insert any product notes here in Red BOLD Italic. Example: "First Shipment expected January 2022" or "Electronics are Not Included".)
VIDEO: Diatone Mamba H743 MK4 FC & 128K ESC Unboxing
Features
- Built-in WIFI so you can upgrade firmware by WIFI and configure the Receiver via the built-in WebUI with your PC or mobile phone
- Upgraded rigid antenna with greater durability and performance
- Improved PCB design is better for heat dissipation
- Solder pads are improved and easier to solder to
- Low-latency and high-refresh-rate RF module
- Open-source receiver based on ExpressLRS
- LED on the top side of PCB
- Built-In ceramic antenna
- SX1280 RF chip
- ESP8285 MCU
USE BULLETED FEATURE HERE INÂ BOLD CAPS.
Add additional feature descriptions here to describe the above.
USE BULLETED FEATURE HERE INÂ BOLD CAPS.
Add additional feature descriptions here to describe the above.
Specifications
(INSERT FLIGHT CONTROLLER TITLE HERE IN BOLD CAPS)
- Maximum receive refresh rate: 500Hz / F1000Hz
- Firmware Version: ExpressLRS v2.4 pre-installed
- Item: RP1 Nano ExpressLRS 2.4GHz Receiver
- FW Target: RadioMaster RP1/2 2400 RX
- Minimum receiver refresh rate: 25Hz
- Antenna: On Board SMT Antenna
- Weight: 2.2g (Including antenna)
- Dimension: 13mm*11mm*3mm
- Working voltage: 5v
- Bus interface: CRSF
- Type: ISM
(INSERT ESC TITLE HERE IN BOLD CAPS)
- Â
(INSERT VTX TITLE HERE IN BOLD CAPS)
- Â
IMPORTANT NOTES
- Insert important warnings or notes here. Example: "Do not overheat." or "Always use the included charger for best performance."
Recommended (Not Included)
- Â (Insert recommended products here. Example: "Battery: Lumenier 10000mAh 6s 25c Lipo Battery")
Links
- Â (Insert links such as manuals, firmware, etc)
Includes
- 1x RadioMaster RP2 ExpressLRS 2.4ghz Nano Receiver w/ Fixed SMT Antenna
- 1x User Manual
- 1x Shrink Wrap
Featured Videos
ADD VIDEO TITLE HERE IN BOLD CAPS
ADD VIDEO TITLE HERE IN BOLD CAPS
More Information
SKU | 19363 |
---|---|
UPC (GTIN) | 764613353129 |
Manufacturer | RadioMaster |
NDAA Compliant | No |
Antenna Connector / Length | Built-in SMT |
Antenna Frequency | 2.4GHz |
Item Returns | This item can be returned |