These require WhitenoiseFPV Race Wire Mini's to be used. They will not work with the regular size Race Wire. For installation, you solder them on to the pads and then solder on your motor wires. You can place them on the bottom of your arms and wire them up to the boards on top. You will need to insulate against the carbon for anything touching the carbon to prevent a short. You will need eight if you would want to light up your whole quad. The LED brightness adjusts based on the speed of your motors, the more you push it, the brighter the LED.

There are solder pads to allow you to wire up additional Racelites to the bottom of your arms. Use the pads labeled "1,2,3" and wire them to the same pads on the second Racelite. You do not need Race Wire for the bottom Racelite boards, however, you must still insulate the bottom of the boards.

The Race Wire Mini is 8x20mm long. These fit onto of the Race Wire mini. They solder on the motor pads at both ends. It is suggested to solder them together prior to putting them on your frame.

Installation instructions here.

Includes

• 1x Racelite Mini LED

Videos