The Hydrophobe is a 255mm water-resistant 5" cine quad with a 2mm aluminum mid plate that doubles as a heat sink for your ESC and VTX. It has a 3mm bottom carbon plate, 6mm arms, and 1.5 mm top plate. A TPU skirt keeps rain, snow, and dirt out.

You can also augment it with sealant to make it as waterproof as possible.

Note: Camera, Battery, Floats, and Electronics NOT included.

Disclaimer: This frame does not claim to be waterproof, but water-resistant. 

Features

• Equipped with an extra-long strap to wrap around the entire frame when mounting the battery.
• Arms are equipped with mounting points for floats.
• The DJI skirt has antenna holders.
• Aluminum Heat Sink Plate
• Waterproof

Build Tips:

• Avoid the use of a short strap looped around the outside of the tabs, that part is not meant for that amount of stress.
• Use a non-conductive thermal paste to transfer heat, but don't let bare boards directly contact the aluminum.
• An Immortal T holder is also available to screw on to the top plate.
• You can print your own parts here. 

Specifications

• Frame Material: Carbon Fiber
• Size: 5" Frame

Includes

• 1x 3D Printed GoPro Hero 8 Mount
• 1x Aluminum Heat Sink Plate
• 1x Extra Long Battery Strap
• 1x 3D Printed TPU Casing
• 1x Hardware Kit
• 1x Bottom Plate
• 4x 6mm Arms
• 1x Top Plate

Note: Camera, Battery, Floats, and Electronics NOT included.