SpeedyBee F405 V5 Flight Controller - 30.5x30.5

The SpeedyBee F405 V5 Flight Controller is crafted with precision to provide reliable performance and multi-platform support. With the built-in Bluetooth chip, full-featured wireless tuning and flashing is possible in the field. The onboard blackbox storage provides 16MB of flash memory, avoiding SD compatibility issues. Multiple UART ports and direct plug connectors simplify setup for beginners and experienced pilots alike.

• New clock sync function improves detection accuracy
• Easier soldering with added direct sockets for GPS and receiver
• Wireless tuning and upgrading
• 16MB onboard blackbox storage

• MCU: STM32F405
• IMU (Gyro): ICM42688P
• USB Port Type: Type-C
• Barometer: SPA06-003
• OSD Chip: AT7456E
• Bluetooth Tuning: Supported. Connect via SpeedyBee App for FC firmware flashing and parameter tuning
• Wireless FC Firmware Upgrade: Supported
• DJI Air Unit Connection: Supports 6-pin direct plug-in or solder connection
• Blackbox: Supported, built-in 16MB storage chip
• Input Voltage: 3-6S LiPo Battery
• 5V BEC Output: 9 groups (4x +5V pads, 1x BZ+ buzzer pad, and 4x 5V pads at corners for LEDs
• 9V BEC Output: 2 groups (1x 9V pad on front, 1x 9V pad on back). Supports PINIO remote on/off control
• MCU & Gyro Power: Independent LDO
• 3.3V Output: 1 group (1x 3.3V pad on front)
• 4.5V Output: 3 groups (3x 4.5V pads on front) Can power receiver & GPS when FC is powered via USB. Max current 1A.
• ESC Signal: M1-M4 pads and 10-pin connector on back
• Servo Signal: S5-S6 pads on the front
• ESC Telemetry Input: Supported (UART 5)
• Betaflight Camera Tuning Pad: Supported (CC pad on front)
• I2C: Supported (GPS connector + pads)
• UART
  • UART1: Bluetooth
  • UART2: front pads for receiver
  • UART3: DJI VTX pads + 6-pin SH1.0
  • UART4: GPS pads + front 6-pin SH1.0
  • UART5: TLM
  • UART6: receiver pads + rear 4-pin SH1.0
• ST LED Pads: Supported, on front G/5V/LED
• Meteor LED Strip Pads: Supported
• Buzzer Pads: Supported
• RSSI Pads: Supported
• Smart Port: Not Supported
• Supported FC Firmware: Betaflight
• Firmware Target Name: SPEEDYBEEF405V5
• Factory Firmware Version: Betaflight 4.5.2
• Configurator Version: Betaflight 10.10.0
• Mounting Holes: 30.5 x 30.5 mm (⌀4mm) side opening
• Dimensions: 39mm x 39mm x 4.9mm (LxWxH)
• Weight: 8.1g

• 1x SpeedyBee F405 V5 FC
• 5x FC Silicone Covers
• 1x 25mm 10-Pin SH1.0
• 1x 80mm 6-Pin SH1.0
• 1x 120mm 6-Pin SH1.0
• 1x 120mm 6-Pin SH1.0 to 4-Pin SH1.0
• 1x 100mm 4-Pin SH1.0
• 1x Quickstart Guide