Holybro Remote ID Module (with case) is a low-cost, small-size, and lightweight module that broadcasts information about UAVs in flight through WiFi and Bluetooth. It supports CAN and serial protocols and is an FCC and CE-approved radio module. The product runs open-source firmware (ArduRemoteID) and provides a standard Remote ID solution, primarily targeting drone manufacturers and system integrators.

Note: This product is designed for the Standard Remote ID Solution, primarily targeting drone manufacturers and system integrators, as you need to do your approval process at the FAA (DoC submission) if you are in the USA. For the most accurate and latest information related to this topic, please refer to the official governance website of your country.

VIDEO: (Insert Video Title here in Bold)

• Standard Remote ID Solution
• Broadcasts Information
• Open-Source Firmware
• FCC and CE-Approved
• Targeted Audience
• Protocol Support
• Lightweight
• Small-Size
• Low-Cost

USE BULLETED FEATURE HERE IN BOLD CAPS.

Add additional feature descriptions here to describe the above.

USE BULLETED FEATURE HERE IN BOLD CAPS.

Add additional feature descriptions here to describe the above.

• Firmware: Supports upgrading firmware via the web interface ("OTA")
• Power: 5V supplied from TELEM or CAN port
• Antenna Connector Type: SMA Connector
• Radio Module: Espressif ESP-C3 module
• Operating Temperature: -40°C to +85°C
• Range: > 5km detection range
• Protocol: CAN & Serial
• Mount: M2 screws
• Weight: 27.5g
• Case: Yes

IMPORTANT NOTES

• Insert important warnings or notes here. Example: "Do not overheat." or "Always use the included charger for best performance."

•  (Insert recommended products here. Example: "Battery: Lumenier 10000mAh 6s 25c Lipo Battery")

•   (Insert links such as manuals, firmware, etc)

• 1x Holybro Remote ID w/ Case
• 1x JST GH 6pin 150mm cable
• 1x JST GH 4pin 140mm cable
• 1x Antenna

ADD VIDEO TITLE HERE IN BOLD CAPS

ADD VIDEO TITLE HERE IN BOLD CAPS