Introducing the MATEKSYS ExpressLRS 2.4GHz PWM Vario Receiver - ELRS R24-P6V, your go-to solution for reliable RC control. With PWM Vario capability, it offers precise and customizable control for your aircraft. Compatible with ExpressLRS systems, it ensures seamless integration and outstanding performance. Say goodbye to signal worries and hello to precise maneuvering with the MATEKSYS ExpressLRS R24-P6V.

Note: (Insert any product notes here in Red BOLD Italic. Example: "First Shipment expected January 2022" or "Electronics are Not Included".)

VIDEO: (Insert Video Title here in Bold)

• Outstanding Performance
• Versatile Compatibility
• PWM Vario Capability
• Quality Construction
• Seamless Integration
• Reliable RC Control
• Compact Design
• Signal Stability
• User-Friendly

FIRMWARES

• Receiver Target: Generic ESP32 PWM Vario 2.4GHz RX, or RadioMaster ER6-GV, or RadioMaster ER6-G.
• The receiver comes preloaded with ExpressLRS 3.3.2 and a binding phrase "123456". It will never enter binding mode if using the traditional binding procedure.
• You need to reflash it with your binding phrase OR connect it to your PC/phone via WiFi and set your binding phrase in WebUI.

FLASHING VIA UART

1. Disconnect ESC and servos from the receiver first.
2. Wire the receiver into the USB-TTL adapter, with TX (PWM 2 pin) on the receiver connected to the Rx on the USB-TTL, and RX (PWM 3 pin) on the receiver connected to the Tx of the USB-TTL. Wire 5V and GND of the USB-TTL to “V” and GND of the Receiver.
3. Press the boot button while powering on the receiver, then release – the Red LED on the receiver should now be solid.
4. In the configurator, select the target Generic ESP32 PWM Vario 2.4GHz RX, RadioMaster ER6-GV, and “UART” for the Flashing Method. Set your bind phrase and Firmware Options. Check “erase before flash” and “Force Flash”.

• ExpressLRS Firmware: ESP32-PICO-D4, SX1281
• Diversity: Antenna-switching, default ANT1
• Power dissipation: 60mA~80mA @ 5V IN
• Telemetry power: 22.5dBm (180mW)
• Power supply: 4-13V DC @ "V" Pad
• Antenna connector: IPEX MHF-1
• Barometer: SPL06-001 (Vario)
• Receiver output: 6x PWM CH
• VBAT voltage sense: 0~25.5V
• RF Frequency: 2.4GHz ISM
• PCB size: 30mm x 18mm
• Weight: 4g with antenna
• PA/LNA: SE2431L

IMPORTANT NOTES

• Powering the receiver with Reverse Voltage will damage the regulator chip. Double-check the power wires connected to the receiver.

•  (Insert recommended products here. Example: "Battery: Lumenier 10000mAh 6s 25c Lipo Battery")

• Full resolution switch configuration modes
• ExpressLRS Firmware  
• Flashing via UART
• Flashing via wifi

• 1x MATEKSYS ExpressLRS 2.4GHz PWM Vario Receiver - ELRS R24-P6V
• 3x Dunpoint 2.54 pin lines (Board is shipped unsoldered)
• 2x IPEX MHF1 Antennas - 15cm

ADD VIDEO TITLE HERE IN BOLD CAPS

ADD VIDEO TITLE HERE IN BOLD CAPS