The Matek F722-Mini SE Flight Controller is an F7 FC with built-in Baro, BEC 5V/2A, MPU6000 (SPI), AT7456E (SPI), and DJI OSD and supports MATEKF722mini INAV and many other cool features!

Specifications

• MCU: 216MHz STM32F722RET6
• IMU: MPU6000 (SPI)
• OSD: AT7456E (SPI)
• Baro: Infineon DPS310 (I2C)
• Blackbox: 32M-byte Flash memory (SPI)
• 5x Uarts (1,2,3,4,6) with build-in inversion
• 1x Softserial supported
• 8x Dshot/Proshot/Oneshot outputs
• 1x I2C
• 1x SH1.0_8pin connector (Vbat/G/Curr/R6/S1/S2/S3/S4)
• 3x LEDs for FC STATUS (Blue, Green) and 3.3V indicator(Red)
• Vbat filtered output power for VTX, Switchable via AUX (modes tab-user1)
• Dual Camera image switchable via AUX (modes tab-user2)
• Convertible 20mm to 30.5mm mounting
• Camera control: Yes
• Smart audio & Tramp VTX protocol: Yes
• DJI OSD: Yes (any spare Uart Tx & Rx)
• WS2812 Led Strip: Yes
• Beeper: Yes
• RSSI: Yes
• Additional ADC for INAV analog airspeed

Power

• Input: 6~36V (2~8S LiPo)
• BEC: 5V 2A
• LDO 3.3V: Max.200mA
• Battery Voltage Sensor: 1:10 (Scale 110)
• No Current Sensor built-in supports external current sensor of PDB/4in1

Firmware

• INAV target: MATEKF722mini
• BetaFlight unified target: MATEKF722mini(MTKS)
• BetaFlight legacy target: MATEKF722SE

Physical

• Mounting
• 20 x 20mm/Φ3mm with Silicon Grommets
• 20 x 20mm/Φ2mm with Silicon & Brass Grommets
• 30.5 x 30.5mm/Φ3mm with Conversion Plate and Silicone Grommets
• Dimensions: 28 x 28 mm
• Weight: 5g

Diagram

Includes

• 1 x FC F722 Mini SE
• 1 x 20mm to 30.5mm conversion plate
• 6 x Silicon grommets M4 to M3
• 6 x Brass grommets M3 to M2
• 1 x SH1.0_8pin cable 5cm
• 2 x SH1.0_8pin connectors