The DroneCAN M8N GPS is the primary CAN protocol used by the ArduPilot and PX4 projects for communication with CAN peripherals. It is an open protocol with open communication, specification, and multiple open implementations.

The Holybro DroneCAN M8 GPS has a UBLOX M8N  module, a BMM150 compass, and a tri-colored LED indicator. It has the STM32G4 Processor and adopted the DroneCAN protocol for communication, making it more reliable and better in dealing with electromagnetic interference compare to serial connection. It does not occupy any serial port of the flight controller, and different CAN devices can be connected to the same CAN bus via a CAN splitter board.

Note: (Insert any product notes here in Red BOLD Italic. Example: "First Shipment expected January 2022" or "Electronics are Not Included".)

VIDEO: Diatone Mamba H743 MK4 FC & 128K ESC Unboxing

• Has a UBLOX M8N  module, BMM150 compass, and a tri-colored LED indicator
• Comes with STM32G4 Processor

USE BULLETED FEATURE HERE IN BOLD CAPS.

Add additional feature descriptions here to describe the above.

USE BULLETED FEATURE HERE IN BOLD CAPS.

Add additional feature descriptions here to describe the above.

(INSERT FLIGHT CONTROLLER TITLE HERE IN BOLD CAPS)

•  GNSS Receiver: Ublox NEO M8N
• Number of Concurrent GNSS: 2 (Default GPS + GLONASS)
• Processor: STM32G4 (170MHz, 512K FLASH)
• Compass: BMM150
• Frequency Band: GPS: L1C/A GLONASS: L10F Beidou: B1I Galileo: E1B/C
• GNSS Augmentation System:SBAS: WAAS, EGNOS, MSAS, QZSS
• Navigation Update: 5Hz Default(10Hz MAX)
• Accuracy: 2.5m
• Speed Accuracy: 0.05 m/s
• Max # of Satellites: 22+
• Communication Protocol: DroneCAN @ 1 Mbit/s
• Supports Autopilot FW: PX4, Ardupilot
• Port Type: GHR-04V-S
• Antenna:25 x 25 x 4 mm ceramic patch antenna
• Power consumption: Less than 200mA @ 5V
• Voltage: 4.7-5.2V
• Operating Temperature:-40~80C
• Size:Diameter: 54mm Thickness: 14.5mm
• Weight: 36g
• Cable Length:26cm
• Other Notes
  
  • LNA MAX2659ELT+ RF Amplifier
  • Rechargeable Farah capacitance
  • Low noise 3.3V regulator

(INSERT ESC TITLE HERE IN BOLD CAPS)

(INSERT VTX TITLE HERE IN BOLD CAPS)

IMPORTANT NOTES

• Insert important warnings or notes here. Example: "Do not overheat." or "Always use the included charger for best performance."

•  (Insert recommended products here. Example: "Battery: Lumenier 10000mAh 6s 25c Lipo Battery")

•   (Insert links such as manuals, firmware, etc)

• 1x (Insert Stack Title Here and edit additional components below)
• 1x High-Frequency 470uf/35V Capacitor
• 1x Amass XT60 Connector
• 2x 12AWG 100mm Wire
• 2x 8-Pin SH1.0

ADD VIDEO TITLE HERE IN BOLD CAPS

ADD VIDEO TITLE HERE IN BOLD CAPS