The Mini Carrier Board for the Pixhak Cube has the standardized DF17 connector, allowing the user to connect it to every version of the Cube flight controller.
With a smaller size and almost the same capabilities as the Pixhawk 2.1 standard carrier board, it allows a better fit-in to those applications which have size limits. Also, it can be equipped with the Cube Mini to better fulfill the demands of customers.
- Dual power input for redundant power, allowing it to automatically switch to another power source if one fails
- Power distribution so you can limit the current at each connector. It helps to avoid overloading when one device draws too much current.
- Voltage protection for both overvoltage and Undervoltage. The circuit will be shut down if the voltage exceeds the limits.
- Dimensions: 47x38x17mm
CubePilot Visual Guide
- 1 x Mini Carrier Board for Pixhawk Cube
Made in Taiwan
- Additional Information
SKU 12068 Manufacturer Hex Technology UPC (GTIN) 736952005731 Static Block fpv_rules
FPV Regulatory Notice
The use and operation of this type of product in the USA and many other countries may require a license and some countries may forbid its use entirely. In the USA, you will need a "HAM" amateur radio license. Learn more about HAM licenses, and find a HAM license exam session in your area. It is your responsibility to ensure that the use of this product meets the requirements imposed by your government's rules and regulations for RF devices. Do not purchase this product if you are unsure of the government requirements or are not able to comply with them. GetFPV cannot be held responsible for your actions if you purchase and/or use this product in violation of your government's regulations. By agreeing to our terms and conditions during the check-out process, you also agree to have read and to understand this notice.