Due to Hurricane Ian, please note there may be short-term shipping delays from our Florida warehouse

Happymodel Moblite6 Ultralight 1S 65mm Brushless Whoop - SPI Frsky

Happymodel Moblite6 Ultralight 1S 65mm Brushless Whoop - SPI Frsky

In Stock

Only left for same day shipping. Order now!
Happymodel Moblite6 Ultralight 1S 65mm Brushless Whoop - SPI Frsky
The Moblite6 features the RunCam Nano4 Lite, Onboard SPI Frsky D8 Receiver, DiamondF4 FR FC, 5A BLheli_S 4-in-1 ESC, 5.8GHz VTX, and more!

About this product

Introducing the Moblite6 Ultralight FPV Whoop! The Moblite6 features the RunCam Nano4 Lite, Onboard SPI Frsky D8 Receiver, DiamondF4 FR FC, 5A BLheli_S 4-in-1 ESC, 5.8GHz VTX, and more! This mini and lightweight whoop (65mm) will take you to hard-to-get places!



  • The lightest 1s 65mm brushless whoop
  • Powerful and efficiency
  • The lightest 1s AIO 5IN1 F4 flight controller
  • New Unibell EX0802 brushless motors
  • VTX power switchable 25mw~200mw
  • Low profile Canopy design


  • Brand Name: Happymodel
  • Item Name: Moblite6 1S 65mm ultra-light brushless whoop
  • Wheelbase: 65mm
  • Size: 80mm*80mm*25mm
  • Weight: 18.5g (without battery)
  • Weight:26g(with Original 1s 300mah Lipo battery )


  • Mode: EX0802 19000KV
  • Configu-ration:9N12P
  • Stator Diamter:8mm
  • Stator Length:2mm
  • Shaft Diameter:Φ1mm
  • Motor Dimension(Dia.*Len):Φ10.5mm*14.9mm
  • Weight(g):1.7g
  • No.of Cells(Lipo):1S only

Flight Controller

  • (Frsky SPI RX version) DiamondF4 FR FC Firmware target: CrazybeeF4F
  • MCU:STM32F411CEU6 (100MHZ, 512K FLASH)
  • Sensor: MPU-6000(SPI connection)
  • Original whoop size compatible
  • Power supply: 1S battery input (DC 2.9V-4.35V)
  • Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready
  • Built-in Betaflight OSD(SPI Control)
  • Built-in 5.8G VTX
  • Built-in SPI Frsky/Flysky receiver
  • Built-in 5V 1A BEC

Onboard 4-in-1 ESC

  • MCU upgraded to EFM8BB21
  • Power supply: 1S LiPo/LiPo HV
  • Current: 5A continuous peak 6A (3 seconds)
  • Support BLHeliSuite programmable
  • Factory firmware: O_H_50_REV16_8.HEX
  • Default protocol: DSHOT600

Onboard Frsky SPI D8 Receiver Version

  • SPI BUS receiver Frsky D8 compatible
  • Compatible Non-EU transmitter D8 model
  • Channels: 8ch
  • Failsafe support
  • No ground interference ( Transmitter and receiver 1 m from the ground): 200m~300m

Onboard 5.8GHz VTX

  • Output power: 25mw~200mw switchable
  • Frequency: 40CH
  • Input voltage: 3.3V 5.5V
  • Current consumption: 300mA(type)
  • Frequency: 5.8GHz 5bands 40 channels(include Race band)
  • Smart audio ready

Runcam Nano 4 Lite

  • Model: RunCam Nano4 Lite
  • Image Sensor: 1/3" CMOS
  • Horizontal Resolution: 800TVL
  • Lens : 2.1mm(M8) FOV 160°
  • Signal System: PAL/NTSC Non-Switchable
  • S/N Ratio: >50dB
  • Electronic Shutter Speed: Auto
  • Auto Gain Control (AGC): Auto
  • Min. Illumination: 0.01Lux@1.2F
  • D-WDR: Auto
  • Day/Night: Color
  • Power:DC 3-5.5V
  • Current: 170mA@5V 180mA@3.3V
  • Housing Material: ABS
  • Net Weight: 1.0g
  • Dimensions: L14mm*W12mm*H9mm

Lipo Battery

  • Capacity:300mAh
  • Voltage:3.8v
  • Continuous Discharge Rate: 30C
  • Size: 57mmx12mmx7mm
  • Weight: 7.5g
  • Connector: PH2.0


  • 1 x 65mm Frame (Mobula6 frame) 
  • 1 x Option1: DiamondF4 FR built-in SPI Frsky receiver 
  • 4 x EX0802 KV19000 Unibell brushless motor 
  • 1 x Gemfan 1219 31mm propeller(4cw+4ccw) 
  • 1 x Runcam Nano4 Lite 
  • 1 x Built-in 5.8G 40ch 25mw-200mw VTX 
  • 2 x 1s 300mah Lipo battery 
  • 1 x 1S USB charger 
  • 1 x Propeller disassemble tool 
  • 1 x Screwdriver 
  • 1 x Happymodel Carry case 

More Information

SKU 15181
UPC (GTIN) 789862858393
Manufacturer Happymodel
Item Returns This item can be returned

Also Purchased

Happymodel Moblite6 Camera Holder (Red)
Happymodel Damping Balls and Screws for Moblite7
Back Ordered
Happymodel Moblite7 650mAh 1S Lipo Battery
Back Ordered
Happymodel PH2.0 1S JST USB Battery Charger