The GEPRC Mark5 DC Pro Frame has a newly upgraded 7075-T6 aluminum alloy camera side plate. This drone is fully adapted to carry DJI’s new O3 camera. Specially designed TPU parts were designed for mounting the O3 VTX module, equipped with an air inlet cooling port, which is conducive to adequate heat dissipation. The DC structure has a wide and unobstructed viewing angle during flight, which is suitable for O3 internal video recording and direct output. MARK5 O3 is shipped with two different camera mounts, which can be mounted with a full range of GoPro action cameras, as well as Naked GoPro 8/10, Insta 360 GO2 and Caddx Peanut, etc. to record beautiful moments for your flight.

Note: This pro version comes with 3D-printed skids to protect the motors and camera, as well as action camera mounts. 

VIDEO: New GEPRC MARK 5 HD O3 is a Dream to Fly! Review

• Mounted a full range of GoPro cameras, as well as Naked GoPro 8, Insta 360 GO2, and Caddx Peanut cameras
• DC structure is suitable for O3 internal recording when no propeller is visible during flight
• Developed specifically for freestyle with deadcat squashed X-arm design
• Pro version frame includes 3D-printed skids
• Upgraded lens aluminum alloy side plate
• Independent capacitor and buzzer cabin
• Shock absorption design
• Emerald Green version

• FC mounting holes: 30.5mm x 30.5mm
• Dimension: 214mm x 168mm x 42mm
• Suitable propeller size: 5″propeller
• Camera installation space: 20mm
• Pro Version Weight: 156.1g
• Bottom plate: 2.5mm
• Wheelbase: 225mm
• Top plate: 2.5mm
• Arm plate: 5mm

FRAME

• 1x 2.0mm front protection plate
• 1x 2.5mm front bottom plate
• 1x 2.5mm rear bottom plate
• 1x Camera aluminum part
• 1x 2.0mm small top plate
• 1x 2.5mm large top plate
• 1x 5.0mm arm limit plate
• 2x 5.0mm front arms
• 2x 5.0mm rear arms
• 1x Set of screws

3D PRINTED PARTS

• 1x Camera vibration reduction mount
• 1x Naked GP 8 camera Base
• 1x VTX antenna mount
• 1x TBS antenna mount
• 1x GP camera mount
• 4x Motor shock pads
• 1x O3 VTX mount
• 1x Front protector
• 1x Buzzer Holder

ACCESSORIES

• 8x M3x8 flight controller shock-absorbing ball
• 1x EVA camera base (with backrest)

OTHER ACCESSORIES

• 1x 1.5mm L-type screwdriver
• 1x 2.0mm L-type screwdriver
• 1x 3.0mm L-type screwdriver
• 1x M15x250 Batteries straps
• 2x M20x250 Batteries straps
• 4x 10x50mm Motor hubs
• 1x 3M double-sided tape
• 2x Battery non-slip mat
• 1x EVA camera base
• 1x Antenna fixed tube
• 1x M8 Wrench

ADD VIDEO TITLE HERE IN BOLD CAPS

ADD VIDEO TITLE HERE IN BOLD CAPS