The GEPRC Cinelog30 V3 WTFPV Drone is designed for smooth, stable flying and crisp cinematic footage. Its sturdy frame includes added protection for internal parts, a shielded camera mount, and dust-proof covers to keep everything clean. The smart layout keeps wires tidy and secure, while the powerful motors and lightweight design allow for up to 8 minutes of flight on a single battery.

Choose a Receiver:

• ELRS 2.4GHz 
• TBS Crossfire
• DJI PNP

Note: FPV System is NOT included.

• Impact-resistant camera canopy
• Wrap-around electronics bay
• Aluminum-reinforced frame
• Add your own FPV System
• Clean rear PDB layout
• Dust-proof data plugs
• 1404 3850KV motors
• F722 45A 32-bit AIO
• Up to 8:10 flight time
• DT76mm x3 props

• Flight Time: 8 minutes 10 seconds (tested at slow cruising speeds; may vary)

• Recommended Battery: LiHV 4S 660–720mAh

• Flight System: TAKER F722 45A 32Bit AIO

• Carbon Fiber Plate Thickness: 2.5mm

• Propeller: HQprop DT76mmx3 V2

• FC Firmware: GEPRC_F722_AIO

• Motor: SPEEDX2 1404 3850KV

• Battery Connector: XT30

• MCU: STM32F722RET6

• Wheelbase: 128mm

• Gyro: ICM 42688-P

• FPV System: None

• ESC: 32Bit 45A

• Flash: 16MB

• 1x GEPRC Cinelog30 V3 WTFPV Drone (No FPV System - Add your own VTX/Camera/Antenna)
• 2x Propellers (Set of 4)
• 1x Accessories Set