A 20x20 mounted 35A AIO board featuring KISS flight tuning from FETtec. Featuring the powerful G4 flight processer for ultimate performance. Two dedicated BECs for switchable power, and full sine-wave control for the ESC.

Specifications

Flight Controller

• Latest STM32G4 processor

  • 170Mhz + Math accelerator

  • MPU6000

• Designed for 12-25V supply voltage (3S-6S Lipo)

• 2x onboard BEC (max. 600mA each)

  • 5V BEC for RX

  • 5V/16V BEC for VTX (configurable and real pit*)

• 1x 8 pin connector for solderless connection to VTX, camera, and OSD of the digital systems

  • VCC, GND, Video in, Video out, BEC 5V/16V, VCS/TX3, RX3

• 2x 4 pin connector for receiver and VTX

  • Signal, telemetry, 5V, gnd

  • Gnd, 5V, TX1, RX1

• 5 UART serials

  • UART 1 free

  • UART 2 occupied by receiver

  • UART 3 free

  • UART 4 occupied by OSD, can be used elsewhere depending on configuration

  • UART 5 occupied by ESCs / TLM / Onewire

• Solder pads for RGB LEDs

• Supported ESC Protokole

  • PWM, Oneshot125, Oneshot42, Dshot150/300/600/1200/2400, FETtec Onewire

• KISS FC firmware 

*real pit mode:supply pad switchable

4-In-1 ESC

• Active current limiting @ 35A
• Input voltage: 3s-6s
• High-quality 40V MOSFETs
• STM32G071 @ 64MHz
• Up to 128 kHz Motor PWM
• Full sine wave control
• Automatic input signal detection
• PWM, Oneshot125, Oneshot42, Dshot150/300/600/1200/2400, FETtec Onewire
• FETtec ESC firmware

OSD

• Graphic OSD (STM32)
• Full KISS Tuning
• Filter (PIDs, Rates, Settings)
• LED control (RGB LED, Racewire)
• VTX
• Live data graphs (Voltage, motor rpm, current, motor temp, gyro values, link quality)
• KISS GPS support + live map
• Custom graphic pilot logo
• Stick overlay
• Custom layout
• can be deactivated for usage of digital systems
• Connector type: JST-SH-1mm

Dimensions

• Maximum outside dimensions: 30 x 37.5mm
• Mounting hole arrangement: 20 x 20mm with M2 mounting hole (expandable to M3)
• Overall Height: 7.9mm
• Weight: 8.9g

Includes

• 1x FETtec KISS AIO Flight Controller and 35A 4-In-1 ESC
• 1x Capacitor 50V 470µF
• 2x 4 pin cable with JST connector
• 1x 8 pin cable with JST connector
• Standoffs