Introducing the SpeedyBee F405 WING MINI Flight Controller, your ultimate companion for smooth and stable flights. Engineered with precision and compactness in mind, this mini marvel is tailor-made for winged aircraft enthusiasts. Equipped with an F405 processor, it ensures lightning-fast response times and unparalleled performance. Plus, its compact size makes installation a breeze, perfect for small-winged setups. Say hello to precision control and goodbye to turbulence with the SpeedyBee F405 Wing Mini Flight Controller.

Note: (Insert any product notes here in Red BOLD Italic. Example: "First Shipment expected January 2022" or "Electronics are Not Included".)

VIDEO: (Insert Video Title here in Bold)

• Tailor-made for Winged Aircraft
• Enhanced Performance
• Precision Control
• Compact Design
• Easy Installation
• F405 Processor 

PDB BOARD

• The VTX power interface Vv offers two power supply options: direct battery voltage or integrated BEC 5V (sharing the 5V4A Servo BEC voltage)
• Battery Current Sensor: 80A continuous, 150A peak Connected to FC board Current (Scale 195 in INAV, 50 A/V in ArduPilot)
• Battery Voltage Sensor: Connect to FC board VBAT, 1K:10K (Scale 1100 in INAV, BATT_VOLT_MULT 11.0 in ArduPilot)
• FC BEC output: Output 5.2V +/- 0.1V DC Continuous current 2 Amps, 3A Peak
• Servo BEC output: Output 5V +/- 0.1V DC Continuous current 4 Amps
• Input voltage range: 726V (26S LiPo)
• TVS Protective diode: Yes
• Weight: 5.5g

FC BOARD

• UART: 6 sets (USART1, USART2, USART3, UART4, UART5, UART6 - Dedicated for Wireless board Telemetry connection)
• Dual Analog Camera Switching: Switch between C1 and C2 using ArduPilot Relay or INAV Modes/USER
• LED: 3x LEDs for FC STATUS (Blue, Green) and 3.3V indicator (Red)
• PWM: 12x (9x pin headers + 2x solder pads + 1x "LED" pad)
• ADC: 4x (VBAT, Current, Analog RSSI, Analog AirSpeed)
• I2C: 1x Used for magnetometer, digital airspeed sensor
• ELRS/CRSF Receiver: Supported, connected to UART1
• SBUS: Built-in inverter for SBUS input (UART2-RX)
• IMU (Gyro & Accelerometer): ICM-42688-P
• MCU: STM32F405, 168MHz, 1MB Flash
• Analog RSSI: Supported, Named as "RS"
• Blackbox: MicroSD Card Slot
• Barometer: SPL006-001
• OSD Chip: AT7456E
• Weight: 5.6g
• Supported FC Firmware:
  • INAV: SpeedyBeeF405WING (default)
  • ArduPilot: SpeedyBeeF405WING

WIRELESS USB EXTENDER

• Buzzer: 5V Active Buzzer
• USB Port Type: Type-C
• Weight: 3.2g

IMPORTANT NOTES

• Insert important warnings or notes here. Example: "Do not overheat." or "Always use the included charger for best performance."

•  (Insert recommended products here. Example: "Battery: Lumenier 10000mAh 6s 25c Lipo Battery")

•   (Insert links such as manuals, firmware, etc)

• 1x 6pin-SH1.0mm GPS Module Cable without Connector on another end (250mm)
• 1x 4pin-SH1.0mm to 3pin-JST 1.25mm FPV Cam Cable (300mm)
• 1x 8pin-SH1.0mm Wireless USB Extender Cable (150mm)
• 1x F405 Wing Mini Standard-Install Shield Board
• 1x F405 Wing Mini Custom-Install Shield Board
• 1x 4pin-SH1.0mm Analog VTX Cable (300mm)
• 1x 6pin-SH1.0mm Digital VTX Cable (300mm)
• 1x 4pin Dupont Single-Head Cable (150mm)
• 1x F405 Wing Mini Wireless USB Extender
• 1x 35V 470uF Low ESR Capacitor
• 1x 90 Degree pin Header (3x10)
• 1x F405 Wing Mini PDB board
• 3x Straight Pin Header (1x10)
• 1x F405 Wing Mini FC board
• 1x Hardware Set

ADD VIDEO TITLE HERE IN BOLD CAPS

ADD VIDEO TITLE HERE IN BOLD CAPS