The Holybro Mini Stack - Kakute H7 FC is a flight controller packed with features, including an onboard VTX ON/OFF Pit Switch with battery voltage monitoring, HD System/VTX & 4in1 ESC plugs, barometer, OSD, 6x UARTs, an easy soldering layout, and much more.

The Kakute H7 Mini builds upon the best features of its F7 predecessor and further improves hardware components and layout. HD-ready, it offers easy plug-and-play compatibility with HD systems like the Caddx Vista while also supporting analog systems. It boasts an onboard "VTX ON/OFF Pit Switch" that allows complete control over the video transmitter's power using a switch on your RC transmitter. This feature proves invaluable during drone maintenance, GPS initialization, race preparation, or when avoiding interference with other pilots.

Equipped with 6x dedicated UART ports with built-in inversion for peripherals, a 4in1 ESC plug, and compatibility with M5-M8 Signal Pads, it facilitates easy support for x8 Octocopter configurations. The integrated BetaFlight OSD simplifies the display of vital information on your FPV screen, such as battery voltage, flight time, warnings, RSSI, and smart audio features. Additionally, it's primed for autonomous flight with the onboard barometer.

The Kakute H7 Mini also offers LED & buzzer pads, and an I2C pad (SDA & SCL) for external GPS/Magnetometers, ensuring seamless integration with additional peripherals for enhanced functionality.

Note: (Insert any product notes here in Red BOLD Italic. Example: "First Shipment expected January 2022" or "Electronics are Not Included".)

VIDEO: (Insert Video Title here in Bold)

• Supports OneShot/MultiShot/DShot PWM
• Separate drive & control circuit
• PWM input, TLM supported
• New and faster F4 MCU
• Supports 3-6S liPo input
• Supports damped light

USE BULLETED FEATURE HERE IN BOLD CAPS.

Add additional feature descriptions here to describe the above.

USE BULLETED FEATURE HERE IN BOLD CAPS.

Add additional feature descriptions here to describe the above.

• Mounting holes: 20x20mm (M2 & M3 Rubber Grommet Included)
• PWM Frequency: 16k to 96k
• Continuous Current: 50A x4
• Voltage output: (VBAT)
• Burst Current: 60A x4
• Firmware: BLHeli_32
• Size: 32 x 40 mm

IMPORTANT NOTES

• Insert important warnings or notes here. Example: "Do not overheat." or "Always use the included charger for best performance."

•  (Insert recommended products here. Example: "Battery: Lumenier 10000mAh 6s 25c Lipo Battery")

•   (Insert links such as manuals, firmware, etc)

• 1x JST SH 6pin to GH 8pin 150mm cable
• 1x JST SH 6pin to GH 8pin 80mm cable
• 1x Holybro Mini Stack - Kakute H7 FC
• 1x Electrolytic capacitor: 1000uF 35V
• 1x JST SH 8pin to 8pin 25mm cable
• 1x JST SH 8pin to 8pin 65mm cable
• 1x JST SH 6pin 150mm cable

ADD VIDEO TITLE HERE IN BOLD CAPS

ADD VIDEO TITLE HERE IN BOLD CAPS