Holybro Kakute F7 HDV AIO Flight Controller
Holybro Kakute F7 HDV AIO Flight Controller
$44.99
Holybro Kakute F7 HDV AIO Flight Controller
The Holybro Kakute F7 HDV All-In-One (AIO) is designed to work with the DJI Digital HD FPV System.
About this product
The Holybro Kakute F7 HDV All-In-One (AIO) is designed to work with the DJI Digital HD FPV System. The GH port available on the board makes it much more convenient for you to connect Holybro Kakute F7 HDV AIO to the DJI FPV VTx, for both signal and power supply.
Note: The port to the DJI air unit on KAKUTE F7 HDV and KAKUTE F7 HDV AIO has been optimized, the output voltage has increased to 9V/2A.
Features
- Supports Betaflight.
- High-performance / low-noise IMU. MPU6000 with 6-axis gyro and accelerometer.
- Ready for autonomous flight: Integrated BMP280 barometer and SCL/SDA for use with external GPS/magnetometer units.
- Dedicated bootloader button for easy firmware flashing.
- Low-profile design fits into even very compact frames.
- 2 oz. copper PCB allows up to 120A maximum continuous current.
- Input voltage 7v to 42v. Power the board directly from the flight pack, up to 6S (on “B+” pad only).
- Automatic voltage monitoring. No need to run a separate vBat wire for voltage monitoring; the KAKUTE F7 HDV AIO monitors voltage directly from the power supply.
- Filtered voltage output for clean, noise-free video. 2 On-board regulators output 5V and 8V. 5V output up to 1.5A to power peripherals such as receiver, FPV camera, or LED strip. 9V output up to 2A to DJI FPV VTx.
- Supports BLHeli pass-through for easy ESC upgrade and configuration.
Specifications
- MCU: STM32F745 32-bit processor
- IMU: MPU6000
- Barometer: BMP280
- USB VCP Driver (all UARTs usable simultaneously; USB does not take up a UART)
- 6 hardware UARTS (UART1,2,3,4,6,7)
- All UARTS support hardware inversion. SBUS, SmartPort, and other inverted protocols work on any UART without “uninvent hack”.
- Supports serial receivers (SBUS, iBus, Spektrum, Crossfire) only. PPM and PWM receivers are not supported.
- TF card for Blackbox logging
- Dimensions: 45x37mm
- Mounting Holes: Standard 30.5mm square to the center of holes
- Weight: 10g
Includes
- 1 x FC board *1
- 4 x M3 Anti-Vibration Silicone Grommet Insert
- 1 x JST GHR 8pin to JST GHR 6pin 80mm cable ( The cable that goes to the DJI Air Unit is included)
- 1 x JST GHR 8pin to JST GHR 6pin 150mm cable ( The cable that goes to the DJI Air Unit is included)
Manual
More Information
SKU | 14824 |
---|---|
UPC (GTIN) | 789862854678 |
Manufacturer | Holybro |
Mounting Pattern | 30.5x30.5mm |
NDAA Compliant | No |
Item Returns | This item can be returned |