The FETtec G4-N 35A AIO is a powerful all-in-one board from FETtec, featuring a G473 flight controller and 35A ESC. This product has no onboard analog OSD, but the use of digital OSDs is still possible as usual.

Note: (Insert any product notes here in Red BOLD Italic. Example: "First Shipment expected January 2022" or "Electronics are Not Included".)

VIDEO: (Insert Video Title here in Bold)

• Powerful G4-N flight processer for ultimate performance
• Two dedicated BECs for switchable power
• Full sine-wave control for the ESC
• A 20x20 mounted 35A AIO board
• KISS flight tuning from FETtec

USE BULLETED FEATURE HERE IN BOLD CAPS.

Add additional feature descriptions here to describe the above.

USE BULLETED FEATURE HERE IN BOLD CAPS.

Add additional feature descriptions here to describe the above.

• Maximum outside dimensions: 30 x 37.5mm
• Mounting hole arrangement: 20 x 20mm with M2 mounting hole (expandable to M3)
• Overall Height: 7.9mm
• Weight: 8.9g
• OSD: None

FLIGHT CONTROLLER

• Latest STM32G4 processor
  • 170Mhz + Math accelerator
  • MPU6000
• Designed for 12-25V supply voltage (3S-6S Lipo)
• 2x onboard BEC (max. 600mA each)
  • 5V BEC for RX
  • 5V/16V BEC for VTX (configurable and real pit*)
• 1x 8 pin connector for solderless connection to VTX, camera, and OSD of the digital systems
  • VCC, GND, Video in, Video out, BEC 5V/16V, VCS/TX3, RX3
• 2x 4 pin connector for receiver and VTX
  • Signal, telemetry, 5V, gnd
  • Gnd, 5V, TX1, RX1
• 5 UART serials
  • UART 1 free
  • UART 2 occupied by the receiver
  • UART 3 free
  • UART 4 occupied by OSD, can be used elsewhere depending on the configuration
  • UART 5 occupied by ESCs / TLM / Onewire
• Solder pads for RGB LEDs
• Supported ESC Protokole
  • PWM, Oneshot125, Oneshot42, Dshot150/300/600/1200/2400, FETtec Onewire
• KISS FC firmware

*Real pit mode: supply pad switchable

4-IN-1 ESC

• Active current limiting: 35A
• Input voltage: 3s-6s
• High-quality 40V MOSFETs
• STM32G071 @ 64MHz
• PWM: Up to 128 kHz Motor
• Full sine wave control: Yes
• Automatic input signal detection: Yes
  • PWM, Oneshot125, Oneshot42, Dshot150/300/600/1200/2400, FETtec Onewire
• Firmware: FETtec ESC

IMPORTANT NOTES

• *Real pit mode: supply pad switchable

•  (Insert recommended products here. Example: "Battery: Lumenier 10000mAh 6s 25c Lipo Battery")

•   (Insert links such as manuals, firmware, etc)

• 1x FETtec KISS G4-N AIO Board - G4-N FC + 35A 32bit 3-6S ESC
• 2x 4 pin cable with JST connector
• 1x 8 pin cable with JST connector
• 1x Capacitor 50V 470µF
• Standoffs

ADD VIDEO TITLE HERE IN BOLD CAPS

ADD VIDEO TITLE HERE IN BOLD CAPS