The F405 MiniTE Flight Controller was designed to be smaller and lighter than its bigger brother, and the 20x20mm mount allows for more space to work with on your build.

Features

• Compared with F722-miniSE 8motors or 6motor+2servos, F405-miniTE supports 8motors+3servos in INAV/BF multirotor mixer
• Redesigned target MATEKF405TE support 8x bi-directional DSHOT.
• Support DJI air unit PnP, and a 10V BEC for DJI OSD or analog VTX
• F405 Mini has a 1MB flash which can run with ArduPilot.
• Convertible 20mm to 30.5mm mounting
• InvenSense GEN3 IMU ICM42605

Specifications

• Mounting Pattern: 20x20 M2/M3, 30X30 M3
• ADC: 4 (VBAT, Current, RSSI, Airspeed)
• Blackbox: 16M-byte Flash memory
• Baro: Goertek SPL06-001 (I2C)
• PWM outputs: 12 (8 Dshot)
• BEC: 5V 1.7A & 10V 1.4A
• Dimensions: 28x28mm
• Input: 6~30V (2~6S LiPo)
• MCU: STM32F405RGT6
• Current Sensor: No
• IMU: ICM42605
• OSD: AT7456E
• Weight: 5g
• UARTs: 6
• PINIO: 2
• I2C: 1

Firmware

ArduPilot hwdef MatekF405-TE

• Copter latest
• Plane latest
• Rover latest

INAV Target MatekF405TE

• inav_3.0.2_MATEKF405TE
• inav_4.0.0_MATEKF405TE

BetaFlight Target MatekF405TE

• set dshot_bitbang = ON when using X6 and X8 DSHOT
• betaflight_4.3.0RC1_MATEKF405TE
• betaflight_4.3.0RC2_MATEKF405TE
• betaflight_4.2.10_MATEKF405TE

Includes

• 1x MATEKSYS F405-MiniTE Flight Controller - Mini 20x20
• 1x SH1.0_8pin cable 5cm (including 2x 8pin connectors) for 4in1 ESC
• 1x SH1.0_6pin to GH1.25_8pin cable 8cm for DJI Air Unit
• 1x 20mm to 30mm conversion plate(blue PCB)
• 6x Silicon grommets M4 to M3
• 6x Brass grommets M3 to M2