Heli-Nation Talon F7 Fusion 20x20 Flight Controller
Heli-Nation Talon F7 Fusion 20x20 Flight Controller
$51.99
Heli-Nation Talon F7 Fusion 20x20 Flight Controller
The Fusion utilizes a dual gyro system set up in 90° phase to each other. These two ICM20602 gyros work in tandem to produce ultra-filtered data to your FC to give you the most locked-in flying experience yet!
About this product
The Talon F7 Fusion is almost identical to the Talon F7 but with one key difference. The Fusion utilizes a dual gyro system set up in 90° phase to each other. These two ICM20602 gyros work in tandem to produce ultra-filtered data to your FC to give you the most locked-in flying experience yet!
Features
- MCU: STM32F722RET6 216MHz
- 2x ICM20602 GYROS 90 deg phase
- Built-in Betaflight OSD
- Up to 8S (36V) direct battery power
- Buzzer pads for external buzzer
- Built-in voltage monitoring resistor
- 5V 2A BEC
- Dedicated LDO for Gyro, noise-free gyro power
- Dedicated LDO for OSD, cleaner OSD signal
- Led strip shares 5V with 5V/2A BEC
- 6 UARTS: UART1, UART2, UART3, UART4, UART5, UART6
- Built-in camera control pin with resistor and capacitor
- 5 Full UARTS with RX AND TX pins
- Logical pin layout for cleanest build possible
- 8 pin 4 IN 1 ESC plug
- Remappable LED pad for additional motor output
- TX3, RX3 can be used for I2C for external compass
- 5V, VBAT selectable VTX and CAM power
- 16M Blackbox flash chip
- No flicker VTX pit mode switch (positive switch)
- M4 Can be selected either led_strip signal or M4 signal for RPM filtering
- 20 X 20 mounting hole with true 25mm board dimensions
Note: To get Motor 4 to work please use the CLI command below using Betaflight V4.0.4. A custom hex is coming soon for 3.5.7 and 4.0.4.
Resource MOTOR 6 None
Resource MOTOR 4 C08
Save
To get 5V to your VTX please go to the mode tab in Betaflight and setup a mode switch for vtx_pit
Videos
Includes
- 1x Flight Controller
- 1x Hardware Kit
- 1x 8pin Harness
- 1x XT30 Connector
More Information
SKU | 10810 |
---|---|
UPC (GTIN) | 032733831040 |
Manufacturer | Heli-Nation |
Mounting Pattern | 20x20mm |
NDAA Compliant | No |
Item Returns | This item can be returned |