The BeeBrain BLV4 AIO Flight Controller is an ideal choice for compact builds, catering to the tiniest setups. This single board integrates a flight controller, a 12AMP 4-In-1 BLHeli_S ESC, a 5.8GHz VTX, and a TBS Crossfire receiver onto a compact 29x29mm platform. The BLV4 offers exceptional performance and an impressive array of features!

• Built-In TBS Crossfire Nano Receiver
• 25x25 Mounting Pattern
• 5w/25w Switchable VTX
• F411 Flight Controller
• 12A BLHeli_S ESC
• 1-2S Voltage
• BMI270 Gyro

• Uart2: Crossfire Nano receiver (Binding instruction: just like the Crossfire Nano, after powering up the drone, hold the bind button on the back side of the USB to get into bind mode)
• VTX: Switchable output power from 5mw- 25mw(for Racing) - SmartMAX(SmartMax up to 400mw)  with BeeTX 5.8Ghz Antenna
• Battery input: 1-2S (For 2S you will need to set the throttle cap at less than 50%)
• Flight Controller Weight: 6.5g(Include antennas and battery connector)
• ESC: 12A BLHeliS Pre-Flash with Bluejay 0.18 target: S-H-40 48kHz
• Receiver: Crossfire Nano receiver with MINIMORTAL T Antenna
• OSD: NBD7456 Graphical OSD compatible with Betaflight OSD
• Flight Controller Size: Outer dimensions: 29x29x7.6mm
• Power Connector: NBD-PH2.0 connector
• Flight Controller Holes: 25.5x25.5mm
• ESC Connector: JST-1.0 3Pin
• MCU: STM32F411
• GYRO: BMI270

• BeeBrain BLV4 CRSF Betaflight 4.4 Firmware

• 1x NewBeeDrone BeeBrain BLV4 CRSF AIO
• 1x MINIMORTAL T Antenna
• 4x Rubber Grommet
• 1x VTX Antenna
• 4x Screw

ADD VIDEO TITLE HERE IN BOLD CAPS

ADD VIDEO TITLE HERE IN BOLD CAPS