Flywoo GOKU GN745 V3 AIO - F7 FC + 45A 2-6S AM32 4-in-1 ESC - ICM42688 25X25

The GOKU GN745 AIO has been Flywoo's flagship AIO, highly praised by Betaflight, INAV, and Ardupilot users. Now, the V3 version takes it to the next level! Upgraded with a two-in-one ESC drive solution, it delivers 45A continuous current and improved motor pad overcurrent protection for enhanced performance. The V3 also adds four direct-plug UART ports and a Type-C interface for greater convenience and seamless connectivity.

Note: Fall 2025, Gyro changed from MPU6000 to ICM42688.

• Improved Layout
• Better Protection
• Type-C Interface
• Compatibility
• Performance
• Plug & Play

• USB VCP Driver: All UARTs usable simultaneously (USB does not occupy a UART)
• Receiver Support: Serial receivers only (SBUS, iBus, Spektrum, Crossfire)
• Receiver Limitations: PPM and PWM receivers are not supported
• Mounting Holes: Standard 25.5/26.5mm (center to center)
• MCU: STM32F745 32-bit processor, 216MHz, 1MB Flash
• BF Flight Controller Firmware: FLYWOOF745AIO
• Hardware UARTs: 7 (UART1, 2, 3, 4, 5, 6, 7)
• Ardupilot Firmware: FLYWOOF745
• Blackbox Storage: Onboard 16MB
• INAV Firmware: FLYWOOF745
• Dimensions: 33.5 x 33.5mm
• IMU: ICM42688
• Barometer: SPL06
• Weight: 9.4g
• Power Output:
  
  • 3.3V: 0.5A max
  • 5V: 2.0A max

• 1x Flywoo GOKU GN745 V3 AIO - F7 FC + 45A 2-6S AM32 4-in-1 ESC - ICM42688 - 25X25
• 1x UNICON UPL Capacitor 25V 470UF
• 1x VTX & Camera Connection Cable
• 1x GPS Compass Connection Cable
• 4x M2x6.6 Shock-Absorbing Ball
• 1x Receiver Connection Cable
• 1x DJI O3 Connection Cable
• 1x XT30 Power Cable
• 4x M2 Rubber Ring