The Lumenier TX5G6R Mini 600mW 5.8GHz 32CH FPV video transmitter is the perfect VTX for long range FPV, and FPV racing where you need the extra power! The high output 600mW transmission power means longer range and better signal penetration compared with lower power transmitters. The TX5G6R has 32 channels including the new Raceband frequencies. Our friends from ImmersionRC first divided the 5.8 band into 8 channels evenly spread out 37MHz from each other, which allows more racers flying at the same time on the same band. Lumenier Raceband transmitters are fully compatible with FatShark and ImmersionRC receivers. The Tx includes a 5v output to power FPV cameras and an on-board microphone to transmit audio to your receiver.
The TX5G6R features an easy to use single button, LED interface. It also comes with a clean pre-wired harness, and only weighs 7.5g! This transmitter outputs a lot of power, so mount it in an area where will have good air flow.
- 32 channels: Covers 4 Bands
- Intuitive and easy to use button and LEDs for frequency selection
- Provides 5v power output for FPV cameras
- Small sized and light weight
- Transmitter frequency: 5658-5925MHz with 600mW power output
- Transmitting distance > 2000m (open area)
- SMA Antenna connector
- Dimensions: 32*22*9mm (not including SMA adapter)
- Audio: Includes on board microphone
- Operating Voltage: 7 - 20V
- Supply current: 260 mA
- Operating Temperature: -10 +85 C
- Video Band Width: 5-6 MHz
- Audio carrier Frequency: 6.5 MHz
- Video Input Level: 0.8,1.0,1.2 Vp-p
- Video Input Impedance: 75 Ohm
- Audio Input Level: 0.8 ,2.0 Vp-p
- Audio Input Impedance: 10K Ohm
- Weight: 7.5g (without antenna)
- Antenna Connector:SMA Female Connector
- Video Format: NTSC/PAL
- Frequency Selection: Single push to change CH, push and hold for 2 seconds to change FR
Frequency and channel frequency table:
|Band 1||FS / IRC||5740||5760||5780||5800||5820||5840||5860||5880|
|Band 2||Lumenier / DJI||5705||5685||5665||5752||5885||5905||5925||5866|
|Band 3||Boscam A||5865||5845||5825||5805||5785||5765||5745||5725|
Compatible with Fatshark, ImmersionRC, Boscam, Foxtech and other generic branded FPV receivers within the same frequency range.
- 1 x transmitting unit (VTX) TX5G6R
- 1 x antennas (2db)
- 1 x power/video cable
- Locking connector, female JST for voltage in, female servo plug for video and 5v out.
- 1 x 12V Step Down Voltage Regulator
Compatible Raceband ready receivers
- Fat Shark 5.8GHZ 5G8RX 32ch Race Band Receiver Module for Dominators
- ImmersionRC Duo 5800 v4.1 A/V Diversity Receiver (Race Edition)
- ImmersionRC Uno 5.8GHz A/V Receiver (Race Edition)
Plug and play with the Lumenier CM-650 Mini FPV Camera!
*Note: TX antenna must be installed properly before it is switched on. Powering on without installing an antenna, or using an improper antenna may easily burn the TX, and such damage is not covered by warranty. When using this transmitter on builds with ESC's that feature regenerative braking, we strongly recommend powering the transmitter with the included 12V step down regulator to protect it from voltage spikes.
Good reliable VTX. review by Thomas on 11/29/2016
I have purchased three of these 600mw transmitters and I have found them to be a very reliable, high quality, low profile, light weight solution for my large and small quads. I've had bad experiences with "budget" electronics from third parties that offer little to know support, so I have decided the just elinate the guess work and stress, and stick with quality components from a reputable dealer like getfpv.
Great tx, could be better review by Austin on 11/27/2016
this is a great vtx but i did manage to break the button along with something for the power system, wish they would add something that would detect if the antenna is plugged in, but other than that it's great. also it does get real hot. also i would get a vtx that has the sma connected to a wire instead of directly to the vtx that way you get more flexibility o the placement of your vtx.
Wow! review by Mike on 12/29/2015
Very small compared to ImmersionRC 600mw , very simple to use & change channel and/or band. Great product for the price
Great Little Transmitter review by Levi on 11/9/2015
I have two other transmitter of different power, and compared to my other 600mw transmitter from a big name, this little transmitter kicks butt! It must be stronger than 600mw, because my range increased when I did the switch. The built in mic is awesome too, as I can use it to monitor engine/propeller noise at distance, for my quad or my plane. This is nearly half the size of my other 600mw unit. The channel change button is easy to access from the top plate of my quad. It fits much better on my QAV250 as well. So far I am very happy, lets hope it can take a beating.
So far best vtx i've used! review by Illest33 on 10/25/2015
I have several boscam 832's and fatshark 250mW video transmitters. The boscam 832's get really hot. If I had to choose between all the ones I have it would be the lumenier TX5G6R. Its a lot smaller than other vtx, has 4 bands, 32 channels and a built in mic. It doesn't get hot like other vtx. I really like the functionality of the single button to change bands/channels. Its 10x easier than trying to move dip switches. Any 160-250mm multi rotor builder knows its a pain to switch channels if you have your vtx mounted under the top plate. I would recommend this vtx!
Awesomeness review by Yancy "TurboRex" Smith on 9/14/2015
What a great Tx for the price. Literally plug and play with the included cable. Rock solid video on my racing quad at any speed. I'm probably going to purchase another one for my old TC3 and do some surface FPV.
P.S. Thanks GetFPV for really really fast shipping.