This part allows for drone manufacturers to comply with FAA "Standard" Remote ID.

It does not allow hobby or commercial users to comply with FAA "Broadcast" Remote ID.

A flight controller running Ardupilot is also required.

Hex Cube ID CAN is a small size (25mm * 13.75mm * 3.5mm ) Remote ID which broadcasts information about UAVs in flight through a Bluetooth 5.2 dual-mode unit and supports CAN protocol. Users can write different codes with one Cube ID only, to adapt to multiple UAVs based on their needs. CubeID is FCC and CE certified.

Note: (Insert any product notes here in Red BOLD Italic. Example: "First Shipment expected January 2022" or "Electronics are Not Included".)

• Different codes with one Cube ID only
• CubeID is FCC and CE certified
• Bluetooth 5.2 dual-mode unit
• Supports CAN protocol
• Small size

USE BULLETED FEATURE HERE IN BOLD CAPS.

Add additional feature descriptions here to describe the above.

USE BULLETED FEATURE HERE IN BOLD CAPS.

Add additional feature descriptions here to describe the above.

• Bluetooth chip: Nordic NRF52840 (Bluetooth 5.2 )
• Dimension: 25mm * 13.75mm * 3.5mm
• Operation Temperature: -40°C ~ 85°C
• Weight: 10g (with cable and antenna)
• Frequency: 2402MHz ~ 2480MHz
• Protocol: CAN & Serial

IMPORTANT NOTES

• Caution: The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
• This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
• NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
• If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
  interference by one or more of the following measures:
  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.
• FCC Radiation Exposure Statement:
  • This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
  • This equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body.
  • This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

•  (Insert recommended products here. Example: "Battery: Lumenier 10000mAh 6s 25c Lipo Battery")

• Installation, settings and updates.

• 1x Hex Cube ID CAN
• 1x Cube ID to GHR-6 Cable
• 1x CAn Cable
• 1x Antenna

ADD VIDEO TITLE HERE IN BOLD CAPS

ADD VIDEO TITLE HERE IN BOLD CAPS