The JHEMCU EP24S ELRS 2.4GHz LR Micro Receiver is based on the open-source architecture and program of ExpressLRS. The receiver uses ESP8285 MCU, so you can upgrade the firmware through WIFI. You can also upgrade the firmware with a general flight controller and external USB-TTL. Because the ELRS receiver uses low-latency and high-refresh RF chips, it is very suitable for FPV competitions and remote FPV. At the same time, these receivers have ultra-light and ultra-small sizes, so they are very suitable for micro-models. Regarding the choice of receiver firmware, our default shipment is DIY_2400_RX_ESP8285_SX1280.

Note: (Insert any product notes here in Red BOLD Italic. Example: "First Shipment expected January 2022" or "Electronics are Not Included".)

VIDEO: (Insert Video Title here in Bold)

• S-Bus output for compatibility with most flight controllers
• Compatible with ExpressLRS ELRS 0.5G firmware
• Diversity antenna for better signal reception
• Based on the open-source architecture
• Supports telemetry data transmission
• Upgrade the firmware through WIFI
• Firmware upgradable via USB port
• High data rate of up to 500kbps
• Ultra-light and ultra-small size
• Support for up to 16 channels
• 2.4GHz frequency band
• High-refresh RF chips
• Micro-sized receiver
• Low latency

USE BULLETED FEATURE HERE IN BOLD CAPS.

Add additional feature descriptions here to describe the above.

USE BULLETED FEATURE HERE IN BOLD CAPS.

Add additional feature descriptions here to describe the above.

• EP24S: Half-wave dipole omnidirectional T-shaped antenna
• Slow flashing: No transmission signal is received
• Frequency range: 2400 MHZ To 2500 MHZ
• Maximum receiving refresh rate: 500HZ
• Working Agreement: CRSF (Betaflight)
• Steady on: receive the transmit signal
• Minimum receiving refresh rate: 25HZ
• Fast flashing: WIFI upgrade mode
• Weight: 0.5g (without antenna)
• Double flash: pairing mode
• Size: 11mm*11mm*3mm
• Working voltage: 5V
• Peak gain: 3.16dB
• ESP8285 MCU
• 2.4G ISM type

IMPORTANT NOTES

• Insert important warnings or notes here. Example: "Do not overheat." or "Always use the included charger for best performance."

•  (Insert recommended products here. Example: "Battery: Lumenier 10000mAh 6s 25c Lipo Battery")

•   (Insert links such as manuals, firmware, etc)

• 1x JHEMCU ExpressLRS 5V 2.4GHz LR Micro Receiver - EP24S
• 1 x Wire Harness
• 1 x T-Antenna

ADD VIDEO TITLE HERE IN BOLD CAPS

ADD VIDEO TITLE HERE IN BOLD CAPS