Note: The next batch shipment estimate is July 2024.

The Lumenier RID complies with FAA regulations and features an integrated UBLOX SAM-M10Q for precise positioning. Its Bluetooth 4 and 5 broadcast transmitter and reverse polarity protection ensure seamless connectivity and safety. Equipped with an onboard magnetometer, efficient power design, and a red/green LED status indicator, it offers reliable performance for drone enthusiasts and professionals alike. The GPS and magnetometer data can be used at the same time by a flight controller for autopilot functionality and OSD information. Each module is individually tested and verified and includes a test report.

VIDEO: (Insert Video Title here in Bold)

• Bluetooth 4 and 5 broadcast transmitter module with integrated antenna
• The onboard connector uses “Basic GPS” pinout from Pixhawk standard
• Functions as a GPS/Mag data source as well for the Flight Controller
• Efficient power design with a wide voltage range of 5-34V (2s-8s)
• Integrated UBLOX SAM-M10Q GPS
• Meets FAA remote ID requirements
• 3.3V Logic levels – ESD-protected
• Onboard LIS3MDL magnetometer
• Red/Green LED status indicator
• Individual test report included
• Reverse Polarity Protection
• NDAA Compliant

USE BULLETED FEATURE HERE IN BOLD CAPS.

Add additional feature descriptions here to describe the above.

USE BULLETED FEATURE HERE IN BOLD CAPS.

Add additional feature descriptions here to describe the above.

• Broadcast Transmitter Module: Bluetooth 4 and 5 (with integrated antenna)
• GPS: Integrated UBLOX SAM-M10Q
• Onboard Magnetometer: LIS3MDL
• Logic Levels: 3.3V (ESD-protected)
• Magnetometer I2C Address: 0x1E
• Reverse Polarity Protection: Yes
• Voltage Range: 5-34V (2-8S)
• Size: 32.5x16.5x10.5mm
• Lightweight 9g

IMPORTANT NOTES

• Onboard connector uses “Basic GPS” pinout from Pixhawk standard
• Red/Green LED status indicator 
  
  • Flashes RED on boot until a fix is detected, then flashes green.
  • The RID Bluetooth functionality is still active without a fix; it just sends “unknown location” data. 
• Use Caution. If the board is not in heat shrink and sits on a conductive surface across these two points, it will short out the battery and could cause damage.

• Want to print your own TPU mounts? Download the 3D Mount Files here:
  
  • Lumenier RID - Remote ID Universal Screw Mount
  • Lumenier RID - Remote ID + Antenna Rear Mount
  • Lumenier RID - Remote ID Strap Mount
• FAA Regulations - Learn more by clicking here.
• Download the Lumenier RID 3D Model STP File to integrate it into your own designs
  • Lumenier RID Module
• Integration Guides
  • Lumenier RID Configuration - Betaflight
  • Lumenier RID Configuration - INAV
  • Lumenier RID Configuration - PX4
• Lumenier RID 2AC7Z-ESPC3MINI1 - Remote ID Declaration of Compliance

• 1x Lumenier RID Remote ID Module
• 1x FAA UAS ID QR Code Sticker  
• 1x Test Report Receipt Sticker 
• 1x GH 6-pin to GH 6-pin 
• 1x GH 6-pin to SH 6-pin 
• 1x GH 6-pin to Pigtail 
• 1x Heat Shrink