The Lumenier 20A OPTO Little BLHeli Pro ESC (also known as the Little Bee) is a top performing electronic speed controller with fast mosfet driven, dedicated driver chips on a quality PCB. The Pro version also features a new Silabs processor, the F396. This gives superior braking and freewheeling performance. The motor braking exceptionally fast thanks to the Silabs processor along with high quality gate drivers. The ESC is OPTO with no onboard voltage regulator, so you may need a 5v regulator to power your flight controller.

The Lumenier Little BLHeli is signal wire programmable with an Arduino Nano v3 board, or other Silab programmers that are compatible with the BLHeli bootloader.

Pre-flashed with the settings below.

• Oneshot / Active Braking (dampened light mode) enabled

Specifications

• Input: 2-4s Lipo
• Constant: 20 Amps
• Burst: 30 Amps
• Weight: 6g w/wires
• Dimensions: 23x12.5x3mm
• Motor wire: 70mm
• Signal wire: 100mm
• MCU: Silabs
• PCB - 4 Layer Blind Pole PCB - 3oz Pour
• Mosfet: N-Channel
• BEC: None

With all ESC's that have active braking we recommend you isolate or filter all sensitive electronics to prevent feedback / spikes.