This PM07 Power Module supplies clean 5.2V to flight controller from the battery and provides current consumption and battery voltage measurements via analog signal through a 6 Pin JST-GH cable, along with integrated esc power & signal distribution for up to 8 ESCs.

PM07 has two 5.2V power output port that can provide redundant power to the flight controller, with independent circuits, BEC IC and circuitry.

It is also great for flight controller that do not have built-in servo header pins like the Pixhawk 6C & Pixhawk 4. It comes with pre-soldered wires, capacitor, and XT60 connector.

Note: This PM07 Power Module uses analog data output and is not compatible to the Pixhawk 5X (Requires a digital PM like PM02D)

VIDEO: (Insert Video Title here in Bold)

• The PM board serves the purpose of a Power Module, as well as a PDB
• Provides regulated power to Pixhawk 4 and ESCs
• Sends information to the autopilot about battery’s voltage and current supplied to the FCs and the motors.

USE BULLETED FEATURE HERE IN BOLD CAPS.

Add additional feature descriptions here to describe the above.

USE BULLETED FEATURE HERE IN BOLD CAPS.

Add additional feature descriptions here to describe the above.

• Input voltage: 2S-14S
• PCB Cont. Current Rating: 90A
• PCB Burst Current Rating: 140A (<60 Sec)
• Output: DC 5.2V & 3A Max 
• Voltage Divider: 18.182
• Amperes per Volt: 36.364
• Dimensions:68*50*10 mm
• Mounting Holes:45*45mm
• Weight: 43.8g

IMPORTANT NOTES

Make the PM07 show the quantity of electric charge of your battery

Mission Planner setup:

1. Connect PM07 to the battery, and also connect it to Mission Planner via USB.
2. Click “INITIAL SETUP” and come to the menu “Battery Monitor”.
3. Make “Monito” into “Analog Voltage and Current”.
4. Make “Sensor” into “9: Holybro Pixhawk4 PM”.
5. Make “HW Ver: "The Cube or Pixhawk" （pixhawk4,pixhawk4mini,pix32v5,pix32）”※   
           “HW Ver:  Durandal（Durandal）”※           
6. Input “18.182” into Voltage divider (Calced).
7. Input “36.364” into “Amperes per volt”.
8. Disconnect and reconnect it to finish the setup.（“Measured battery voltage” shows the current quantity of electric charge of the battery.）

•  (Insert recommended products here. Example: "Battery: Lumenier 10000mAh 6s 25c Lipo Battery")

•   (Insert links such as manuals, firmware, etc)

• 1x PM07 board
• 1x 80mm XT60 connector wire (installed)
• 1x Electrolytic capacitor: 220uF 63V (installed)
• 2x JST GH 10P Cable
• 1x JST GH 8P Cable
• 2x JST GH 6P Cable

ADD VIDEO TITLE HERE IN BOLD CAPS

ADD VIDEO TITLE HERE IN BOLD CAPS