A Hovership exclusive, this compact high power "thruster" LED bar is perfect to be seen in air races and when flying line of sight. The bars are a single color, linear LED with mouting holes and an aluminum backing for heat dissipation. Available in white, yellow, green and blue.

Note

Each LED includes a 12 Ohm 1/2W resistor. This MUST be used with these LEDs to limit the current and prevent them from burning up. Simply solder this on the voltage in line (+) of the bar.

DO NOT run these with more than 12v! They will get extremely hot and burn the resistor and LED module. It is recommended to use an adjustable stepdown voltage regulator. While they can run on 12v, using 9-10v keeps them cool yet still very bright.

If mounting with foam tape and using 12v power, ensure the adhesive can tolerate the heat generated from the LED.

Specifications

• Overall Dimensions: 52*6*2mm
• Emitting Area Dimensions: 37*6mm
• Mounting Holes: M2, 42mm spacing
• Operating Voltage: 9-12v
• Power Consumption: 100mA @ 9v, 230mA @ 12v
• Weight: 1.3g (including resistor)
• LED Chip Type: COB