The NEW Race Spec Mini 20A AFRO is geared for the mini FPV racers, Featuring true 20A capabilities and yet is the same size or smaller than most 12A esc. This was made possible with a new 4 Layer PCB design to handle the current and dissipate the heat. Race Spec also ships with the latest firmware with auto one-shot detection and Comp-PWM enabled. Race Spec is plug and play race ready.
Developed from the ground up, we wanted to build a truly Multi-rotor specific ESC that would offer the best performance and value in the market today. We wiped the slate clean and looked to the community for inspiration and help in designing an ESC that truly could be known as “The Multi-rotor ESC”
Enter Simon and Hamasaki AKA SimonK and timecop. This combination of hardware and firmware expertise in conjunction with the Hobbyking in house engineering team gave us the edge needed to develop an ESC like no other and hence the Afro series was born.
Boasting high efficiency, all N-channel MOSFET design, jitter-free hardware PWM input, and smooth power response the Afro ESC series are set to change the expectations of multi-rotor pilots around the globe. The Afro ESC series ship with multi-rotor specific SimonK software preloaded! No need to reflash. For added convenience the Turnigy USB linker can be used via the PWM signal lead for any future software updates eliminating the need for complicated flashing jigs or the need to cut open the heat shrink.
This version of the Afro multi-rotor speed controller has been developed especially for the growing 250 FPV racing class. The demands of the FPV racer are very high but this speed controller ticks all the right boxes, it is very small and lighweight but still packs a mighty punch.
- Current Draw: 20A Continuous
- Voltage Range: 2-4s Lipoly
- BEC: 0.5A Linear
- Input Freq: 1KHz
- Firmware: afro_nfet.hex
- Discharge wire/plugs: 18AWG/Male 2mm
- Motor wire/plugs: 18AWG/Female 2mm
- Weight: 11.3g (Included wire, plug, heat shrink)
- Size: 25 x 20 x 6.5mm